loading

Staxx Pallet Truck is a professional warehouse equipment manufacturer and pallet jack supplier in China.

All-electric stacker trucks usually need more daily maintenance and inspection

by:Staxx Pallet Truck     2022-03-09

We will use all-electric stackers during the handling of materials in the factory. Now this electric transporter has become the main material handling equipment. With the use of more and more electric series of material equipment, safe operation It has also become a problem that people are very concerned about. What safety operation methods should be paid attention to in operation? The editor will sort out a few points for you here:

1. All electric stacker operators are not allowed to drink alcohol After driving, overweight or speeding, it is forbidden to brake suddenly and make sharp turns. All electric stacker trucks are prohibited from entering places where solvents and flammable gases are stored.

2. The safety device of the all-electric stacker must be complete and intact, the components are sensitive and effective, and the technical performance is good. It is strictly forbidden to drive the stacker with illness. All parts are carefully inspected.

3. Maintain the standard driving state of the all-electric stacker. When the fork is driving off the ground, the fork is 10-20 cm off the ground. When the all-electric stacker stops, the fork is lowered to the ground height to drive; When working in poor road conditions, the weight should be appropriately reduced, and the driving speed of the all-electric stacker should be reduced.

4. When the all-electric lithium pallet truck is running, if the electronic controller is out of control, the main power supply should be disconnected in time.

5. Special attention should be paid to the timely charging of the battery and the correct maintenance of the battery during the use of the all-electric stacker. When charging the battery, pay attention to the method, not only to make the battery fully charged, but not to cause the battery to be overcharged; when the battery is in a state of deficient power, the battery should be recharged several times, and then it can return to normal; check the battery frequently. Whether the distilled water is sufficient, if not enough, it should be replenished in time.

6. In the operation of the all-electric stacker, try to use as little as possible long-distance acceleration. When the all-electric stacker starts and the speed increases, keep the accelerator pedal steady , if the road conditions are good, the stacker will continue to accelerate. When the stacker needs to decelerate, relax the accelerator pedal and lightly step on the brake pedal, so that the energy of deceleration can be fully utilized. If the all-electric stacker has a regenerative braking function, the kinetic energy during deceleration can be recovered. When the vehicle is going down the ramp, do not disconnect the circuit of the drive motor of the all-electric stacker, and gently step on the brake pedal to make the all-electric stacker run in a regenerative braking state, and use the kinetic energy of the vehicle to reduce battery life. energy consumption.

7. During the operation of the all-electric stacker, do not mistake the 'forward, reverse' direction switch as a steering switch. Do not press the brake pedal all the way unless you need to decelerate sharply. During the operation of the vehicle, when it is found that the battery power is insufficient (which can be obtained through the electricity meter, the power loss indicator light and other alarm devices), the battery should be charged as soon as possible to prevent the battery from being over-discharged.

When the all-electric stacker is transporting materials, it must not drive at high speed, but must be slow, because if it is told to drive, it will often take emergency braking; Cause huge friction, shorten the service life of brake assembly and driving wheel, and even damage the brake assembly and driving wheel. When the all-electric stacker is not in use, please place the fork at a low position to prevent the cylinder piston rod from being exposed to the air for a long time and rusting; the driving wheel and front wheel should be free from debris such as broken steps; Disabled.



Ningbo Staxx Material Handling Equipment Co.,Ltd. as one who also teaches operations about how we use our whole operating system as a way to gain advantage and create considerable value and capture value in a sector where, in essence, the environment is quite hostile from a competitive point of view.
Serving others for customers a better life with pallet stacker truck for employees respect and opportunity.
semi electric pallet stacker pallet stacker truck are primarily used for battery operated pallet stacker.
There are different types of , mainly powered pallet truck and pallet trolley.
pallet stacker truck are raising the stakes of social marketing, but they also ease the sales process by providing ways for pallet jack manufacturers to effectively interact with customers.
Custom message
暂无友情链接数据
Chat Online 编辑模式下无法使用
Leave Your Message inputting...