Electric pallet truck daily inspection and safety operating procedures training

Electric pallet truck daily inspection and safety operating procedures training:

1. Before taking over each shift, check whether the wheel bolts are loose, and retighten them if necessary; check the hydraulic oil

position, check the tightness of the brake switch.

2. Check the condition and fastening of wires, connectors and connections.

3. Before turning on the power, the key switch of the electric door should be in the off position, do not turn the accelerator or press the button of the oil pump.

4. Maintain an appropriate starting speed when starting, and it should not be too violent; the pallet truck should gradually accelerate and stop during driving.

car, try to avoid sudden braking when driving fast, and pay attention to reduce driving speed when making sharp turns, so as not to cause damage to the pallet truck

overturned.

5. Pay attention to observe the electricity meter. When the red light of the electricity meter diode flashes, it indicates that 80% of the electricity has been discharged.

That is, the battery is charged.

6. During the walking process of the electric pallet truck, when switching the front and rear gears, the pallet truck must be decelerated to prevent the battery from burning out.

components and damage gears.

7. Driving and lifting should not be carried out at the same time, that is to say, in general, the traveling motor and lifting motor cannot be combined.

The machine should work at the same time, otherwise the discharge current of the battery will be too large, the efficiency will be reduced, and the service life will be affected.

8. Pay attention to whether the sound of the driving system and the steering system is normal. If any abnormal sound is found, the fault should be eliminated in time.

It is strictly forbidden to work while sick.

9. Start, turn, drive, brake and stop smoothly. When turning on wet or slippery roads, you must

Slow down; slow down early when turning.

10. When working on poor road conditions, the weight should be appropriately reduced, and the driving speed should be reduced.

11. When the electric pallet truck forks the goods, lower the goods as much as possible before walking. When the pallet truck lifts the goods, it should generally

Do it in a vertical position. When the fork frame is raised to a high position, no one is allowed to stand under the fork frame;

According to the size of the object, adjust the distance between the forks, so that the goods are evenly distributed between the two forks, and avoid unbalanced load.

12. When forking the goods, the load should not exceed the specified value. The fork must be inserted under the goods, and the goods should be evenly distributed.

Place it on the fork, and no single fork is allowed to pick up objects; pay attention to the surrounding conditions during operation, so as not to touch, collide, fork,

When lifting objects, it should be stable, and the quilt and objects should be placed firmly before lifting and lowering.

13. Pay attention to pedestrians, obstacles and potholes when driving; no one is allowed to stand on the fork, and no one is allowed on the car.

Manned.

14. No one is allowed to stand on the fork or walk under the fork; do not carry unfixed or loosely stacked goods,

Handle larger loads with care.

15. Do not let the pallet truck run out of power until the pallet truck cannot move before charging, which will shorten the life of the battery.

At the same time, do not let the tool close to the two stages of the battery, so as not to cause sparks or short circuit.