Manual hydraulic truck shifting and operation steps

Manual hydraulic truck shifting

The manual hydraulic truck is also known as the ground cow. It has a simple structure and a high utilization rate. It is generally used in supermarkets to transport goods. The manual hydraulic truck has three gears, and different gears have different functions.

In the middle is the positioning gear, in which the car neither ascends nor descends.

Pulling up is a neutral gear, that is, a descending gear, a pressure relief gear.

Pulling it down is to engage the gear, that is, to close the oil seal to allow its hydraulic pressure to rise.

Sometimes when there is air in the oil pump of the manual hydraulic truck, it does not rise or rises slowly during use. At this time, it is only necessary to change the gear to remove the air. Just shift the gear in gear up and press the handle a few times as you normally do. At this time, although the car body will not rise, it can effectively remove the air in the pump body. Generally, the air can be emptied by pressing it about 10-20 times.

Operation steps of manual hydraulic truck

The manual hydraulic truck is a small volume hydraulic device, small in size, light in weight, can work in narrow passages and can enter the elevator with full load. The car body is compact, flexible in movement, light in weight and good in environmental protection, and is widely used in factories, warehouses and other occasions that require horizontal handling. The operation steps of manual hydraulic truck are as follows:

Suppression: Push the control handle to the lower position, and press the direction handle to suppress the lithium pallet truck. The weight of the fork goods must not exceed the limit of the forklift.

Pulling goods: After pressing the goods off the ground, hit the control handle to the neutral position to drag the goods. Do not run while pulling the goods, you need to slow down.

Depressurization: After pulling the goods to the destination, turn the control handle to not yet, and depressurize the forklift until the goods touch the ground.

Empty truck operation: When running empty truck, the forklift should be properly pressed and raised to prevent the front axle support frame from contacting and wearing on the ground.

Ningbo Staxx Material Handling Equipment Co.,Ltd. undertakes bulk operations and specializes in undertaking corporate offers to cater the needs of different companies.
Ningbo Staxx Material Handling Equipment Co.,Ltd. would like to provide our customers with as near perfect protection, as near perfect service as is humanly possible and to do so at the lowest possible cost.'
Technology upgrades can pay for themselves quickly by improving pallet stacker truck and enabling employees to accomplish more in less time. It may be time to focus on hand pallet truck manufacturers to ensure they run smoothly and efficiently.