Safety regulations for electric stacker

Our factory workshop is not very big, and the space is not rich. The large electric forklifts can’t get in and can’t complete the work, so we produced the electric stacker, which is not as big as the electric forklift. However, he has the unloading and loading requirements that electric forklifts can meet, and when electric stackers work at high places, they work more finely and meticulously than electric forklifts, which also greatly reduces the labor of manual work at high places. Difficulty, do we think it is safe to operate like this? Let our Jiangsu electric forklift manufacturer show us the usage specifications of the vehicle.

First of all, we need electric stacker for pre-job training: Our operators need to pass the training before they can operate the equipment. During the operation, they need to abide by the relevant safety operation requirements. No one can stand on the lower part of the fork or around it. It is necessary to study carefully and strictly abide by the operating procedures, and be familiar with vehicle performance and road conditions in the operating area. Jiangsu electric forklift manufacturers remind us to master the basic knowledge and skills of forklift maintenance, and do a good job in vehicle maintenance according to regulations.

In the operation of electric stacking vehicles, try to use less time and long distances to increase the shelf speed. When the vehicle starts and the speed increases, hold the accelerator pedal. If the road conditions are good, the vehicle will continue to accelerate. When the vehicle needs to decelerate, relax the accelerator pedal and lightly step on the brake pedal, so that the energy of deceleration can be fully utilized. If the vehicle has a regenerative braking function, the kinetic energy during deceleration can be recovered. Jiangsu electric forklift manufacturers tell us that when the electric stacker is going down the slope, do not disconnect the circuit of the driving motor, and gently step on the brake pedal to make the vehicle run in regenerative braking state, and use the kinetic energy of the vehicle to reduce the load on the battery. energy consumption.

After the work is over: the electric stacker needs to be parked in a dry and flat place, the mast of the equipment should be in a vertical position, lower the position of the oil cylinder; turn off the power switch. Check the tightness of the hydraulic system, check the power of the battery, and charge it in time.