Battery antifreeze tips for semi-electric stackers in winter

The weather is gradually getting colder, and the temperature in some areas has even reached below zero. Therefore, for these friends, the antifreeze work of pallet trucks still cannot relax their vigilance. Although the semi-electric stacker is often used for the loading and unloading of energy, the anti-freezing work cannot be ignored, especially the battery of the semi-electric stacker should do a series of anti-freezing work to ensure that the equipment can be used without obstacles and work efficiency. At the same time, it also prolongs the service life of the equipment, thereby achieving the purpose of saving operating costs. Next, the storage pallet truck manufacturer will take you to learn some tips about the antifreeze of the semi-electric stacker battery.

1. Pay attention to the battery warm-up work in cold weather

Speaking of the battery's antifreeze, we have to say the battery's warm-keeping work. The battery is the core power component of the semi-electric stacker, and the performance of the battery is closely related to the temperature. The manufacturer of the storage pallet truck recommends keeping the working environment temperature of the battery at about 25°C. When the temperature is low in winter, friends who have the conditions must store the semi-electric stacker in a room with a suitable temperature.

2. Immediately after use, the battery is fully charged

When the weather is cold, once the power of the semi-electric stacker is found to be exhausted, it should be charged in time. Avoid running out of power. If possible, the warehouse pallet truck manufacturer reminds everyone to keep the semi-electric stacker fully charged, so as to avoid running out of electricity halfway through the work, and it will not affect your work progress and cause unnecessary trouble. When charging, disconnect the charging circuit and the chopper to avoid affecting the charging. In addition, the overvoltage generated by the charger will damage the chopper, and the wiring from the battery to the electronic control should be arranged in parallel and as short as possible.

3. The battery should be waterproof and moisture-proof

When the semi-electric stacker enters the room from the outside, the surface of the battery will suddenly appear in the warm room with cold air. Frosting phenomenon. Therefore, it is necessary to do a good job of waterproofing and moisture-proofing the battery to prevent damage to the battery. In addition, regularly clean the dust inside the DC motor, check whether the carbon brushes and springs are normal. The battery is the core of the semi-electric stacker, so distilled water should be added in time.

The above are some antifreeze tips summarized by storage equipment manufacturers for you. If you have any questions, you can consult online.