How to use the stacker

Stacker refers to various wheeled handling vehicles for loading and unloading, stacking, stacking and short-distance transportation of palletized goods. The International Organization for Standardization ISO/TC110 is called an industrial vehicle. So, what are the correct operation methods of the electric stacker?

The warehouse keeper must be familiar with the stacker in an open space. After being familiar with it, he can use it on the first and second floors of the shelf. After being familiar with it for a month, he can operate the third, fourth, and fifth floors of goods.

1. Start the stacker: check to make sure the battery is fully charged and the indicator light is on. Insert the key into the electric lock, turn it clockwise, and lift the emergency stop switch to start the stacker.

2. Forward/backward of the stacker: turn the control handle of the stacker to your side, and swing down at an appropriate angle. (leave the vertical position but can not be pressed to the lowest position), and then turn the two knob switches with the thumb: if the switch is turned forward, the stacker will move forward, if the switch is turned backward, the stacker will move backward . The forward/backward speed is controlled by the rotation angle of the rotary switch. When starting or when the surrounding space is small, in order to ensure safety, the moving angle should be controlled to be smaller to slow down the driving speed. There is a low-speed button on the handle, which limits low-speed driving when pressed.

3. Lifting of the fork of the stacker: Press the button with the rising mark on the control handle with your fingers, and the fork will rise; press the button with the falling mark, and the fork will descend; after releasing it, the lifting will stop immediately.

4. Belly safety switch: When the stacker backs up, if your body collides with the red belly switch, the stacker will stop immediately and move a short distance in the opposite direction to the forward direction. This is mainly to prevent your body from being squeezed and injured .

5. Conventional parking of the stacker: When you need the stacker to stop smoothly, release your thumb, and the rotary switch will automatically reset. At this time, a reverse current will be generated through the controller, and the stacker will move a very small distance Then stop smoothly.

6. Vehicle charging: When the battery sends out a flashing signal, that is“run out of battery”In case of an alarm, it should be charged in time. When charging, first turn off the electric lock and pull out the key from the electric lock.