The use of electric forklifts should remember not to carry unfixed or loose goods

Electric forklifts are very popular in the logistics industry. Although their structure is relatively simple, there are still some operating rules. Whether it is operating any kind of mechanical equipment, the first thing to pay attention to is stability, and electric forklifts are no exception. The following forklift manufacturers will tell you about the operation of electric forklifts.

Operating matters of electric pallet truck:

1. Before using the vehicle, it should be strictly checked, it is strictly forbidden to drive out of the vehicle with faults, and it is not allowed to forcefully pass through dangerous or potentially dangerous road sections.

2. It is necessary to pass the examination of the relevant department and obtain the operation certificate issued by the government agency before driving the forklift.

3. Before the battery forklift is not in use, drop the forks to the ground and place the pallet stacker neatly, stop and disconnect the whole vehicle

4. Do not stand on the forks People, people are not allowed to run on the forklift F

5. Be careful to handle large-sized goods, do not handle unfixed or loose goods

5. p>

6. Start smoothly, decelerate before turning, don’t drive too fast, brake and stop smoothly

7. When the power supply is low, the battery forklift’s power protection device will automatically turn on. The fork of the forklift will refuse the lifting operation, and it is forbidden to continue to use it. At this time, the empty truck should be driven to the charger position to charge the forklift.

8. Regularly check the electrolyte, and it is forbidden to use open flame lighting to check the battery electrolyte.

9. Before running, check the effectiveness of the brake system and whether the battery power is sufficient. If defects are found Just operate it after the pre-operation process is completed.

10. Normally, intelligent chargers do not need manual intervention. For non-intelligent chargers, you can manually intervene in the output voltage and current value of the charger. Usually the voltage The output value can be 10% higher than the nominal voltage of the battery, and the output current should be set to about 1/10 of the rated capacity of the battery.

The above 10 points are all precautions for the operation of electric pallet stacker. We are not allowed to use a single fork to move the goods, nor to use the forks to pick up the goods. All the forks are inserted into the goods. down and place the load evenly on the forks. When charging the battery forklift, first disconnect the working system of the battery lithium pallet truck from the battery, then connect the battery to the charger, then connect the charger to the power socket, and turn on the charger.