How are the components of the electric hydraulic pallet truck installed?

How are the components of the electric hydraulic pallet truck installed? In the warehouse workshop, the application of electric hydraulic pallet trucks is gradually popularized. When bosses buy electric hydraulic pallet trucks from electric pallet truck manufacturers, due to the consideration of transportation space and safety issues, they are often not finished products, and some parts need to be installed by themselves. Then, the installation of electro-hydraulic pallet trucks has become a very important issue. Let's take a look at the principles and steps of the parts installation of the electric hydraulic pallet truck.

The installation of electric hydraulic pallet trucks usually follows the installation principles from bottom to top, from inside to outside, from back to front, and from left to right. Let's take a look at the specific steps below:

The piston ring should be used as a set and cannot be disassembled at will. Install from the third ring.

Do not touch the piston, crankshaft bushing surface, connecting rod, piston, crankshaft, camshaft at will. The installation of these parts must be evenly oiled for protection and lubrication.

Grease the o-rings as needed, then install the cylinder liner. Remind everyone not to knock the cylinder liner during installation.

Remember not to install the ring vertically or horizontally. When installing the ring port, it is advisable to stagger it by at least 120°.

Manufacturers of electric pallet trucks usually require customers to install cylinder head gaskets after oiling, this process is irreversible.

When installing the cylinder head screws, the wrench should be tightened 2-3 times from the middle to the four sides, and the cylinder head screws should be tightened to ensure that each screw is evenly stressed, and then separated from the middle to both ends. Tighten the crankshaft bushing connecting rod 2-3 times.

Install the piston rod in the original direction of the piston as required. Install the piston rod using a special tool. Also, without hitting the piston, spread the oil evenly on the connecting rod bushing.

When installing the high pressure fuel injection pump gear and camshaft, pay attention to the alignment of the gears. The above are the principles and steps for electric pallet truck manufacturers to install electric hydraulic pallet truck parts. Hope our content is helpful to you.