The Secret to Longevity of Electric Pallet Truck Chargers

The secret to longevity of electric pallet truck chargers, Pallet Truck Co., Ltd. is a professional company engaged in the sales of pallet trucks.

How to extend the service life of the pallet truck charger? Pallet trucks come to tell you.

Use a dry cloth or anti-static cloth to keep the charger clean; do not use chemical or abrasive cleaners to avoid damage to the case; must be protected from strong shocks from clicking or exposure to high temperature and humidity In the environment; ;When the battery is fully charged, first disconnect the input AC power supply, and then disconnect the connection between the charger and the battery; under the condition of no one or long-term use, the AC power supply must be disconnected; during the charging process, do not cover the charging The ambient temperature should not be higher than 40°C; this charger is only for indoor use, beware of rain; it is forbidden to charge non-rechargeable batteries; the interval between two startups is not less than 10 seconds. The charger should be kept clean frequently to prevent the intrusion of dust and moisture. When not in use for a long time, it should be placed in a dry and ventilated place indoors and covered with a hood. After a period of time, it should also be powered on to dehumidify. During the charging process, the ventilation shutters on the casing cannot be shielded to ensure that the heat generated in the charger diffuses in time. After the fuses in the input and output circuits have blown, they must be replaced according to the required specifications. The fuse should not be too thick and must never be replaced by wire. When the AC input voltage is 110 volts, the input current is 10.8 amps. When the AC input voltage is 220V, the input current is 5.4A. When two rectifiers work at the same time, the output current can reach 12 amps, and when one rectifier works alone, the output current does not exceed 6 amps. Appropriate fuses should be selected based on the input and output currents. The brushes of the sliding contacts of the transformer should be kept in good contact. When the part of the brush exposed to the copper frame is less than 2 mm, it should be replaced in time.