How to spend the running-in period of electric hydraulic pallet truck

The newly purchased electric hydraulic pallet truck may not be very smooth, and many functions may be unskilled in operation, which requires a period of human-machine running-in. What the sales want to tell you is that the new car should not carry heavy goods in the early stage of running-in. Next, we will tell you what to do in the first 100 hours of the initial run-in stage of the new car, and how to maintain the new pallet truck.

First carefully check whether there is any problem with the electric hydraulic pallet truck equipment, if any problem is found, carry out pre-inspection and maintenance in time according to regulations. Oil changes and lubrication should be done earlier than specified. If it is in normal condition, warm up the pallet truck before driving, no matter what season it is. It is suggested to avoid emergency braking and emergency steering during driving. It is recommended that you start slowly. Do not run the engine at high speed with no load.

The safe driving of electric hydraulic pallet trucks is more than the responsibility! In order to reduce the occurrence of more electric pallet truck safety accidents, 1 ton electric pallet truck sales hope that the majority of electric pallet truck drivers should keep in mind not to drive the pallet truck in the following situations:

People Resolutely do not start if you are not seated firmly;

Resolutely do not start if the safety equipment is in poor condition; Resolutely do not start it;

It is stipulated that the goods will not be started and will not start; p>

The frame station person is not determined not to start;

The equipment is too long, super high, overloaded and it is not started;

It is not started without inspection.

If the electric hydraulic pallet truck has not been used for a long time, it is suggested that the bearings should be lubricated once within two weeks of starting to use. When adding lubricating oil, pay attention to use new oil to squeeze out all the old oil, and lubricate it more than twice. Remember to clean the oil caps, plugs and nipples of dirt before lubricating the bearings to prevent dirt from falling into the inside of the pallet jack structure.

There is another point that I think needs to be brought to your attention. When injecting the lubricant with the grease gun, it should be injected into the joints of the parts until the lubricant is squeezed out. Change the seasonal lubricant or oil in summer or winter, and the performance of the whole vehicle parts of the lubricated electric pallet truck can be optimized, thereby improving work efficiency!