How to stack goods at right angles with manual hydraulic trucks

Manual hydraulic truck is a common handling tool in warehouse logistics and transportation, which can not only reduce the physical strength of workers, but also improve the speed of handling, loading and unloading of goods. However, when the truck walks in the workshop warehouse, it often encounters various obstacles, right-angle corners and other access obstacle areas. In order to help workers quickly complete the right-angle stacking work, the manufacturer has summarized the following operation tips.

What is a right-angle stacking channel?

The width of the right-angle stacking aisle is an important indicator of whether the forklift can have enough space to operate after entering the workplace. In layman's terms, it is the distance between the two obstacles when the forklift goes straight into two obstacles (such as two rows of shelves), and then rotates 90 degrees to pick up the goods. In theory, the smaller the width of the right-angle stacking channel, the better, which can save the space for placing the goods.

How to complete the stacking task at right angles?

First of all: the centrifugal force of the manual pallet truck when turning is easy to roll the truck over (especially when going down a steep slope or when the height of the items being carried is large). In order to reduce the centrifugal force, it is necessary to reduce the speed of the mini hand pallet truck, which is a safety measure.

Secondly, it is also important: the main trick for the truck to turn at a right angle is not to hit the direction of the turn prematurely when turning.

The specific operation steps of the manual hydraulic truck are as follows:

1. Before turning the ground cow, you must drive on the outside as much as possible. When the front of the manual hydraulic handling lithium pallet truck is about to reach the opposite sideline (about 50cm-70cm), it starts to turn inward. When you feel that the middle of the manual lifting forklift is about to pass the apex of the right angle, slowly return to the positive direction, and then slowly turn the forklift in the right direction. Explosion-proof hand pallet truck head correction. The above steps should be slow, steady, and not impatient.

2. The safety clearance is generally 20mm at the front and the rear. What needs to be considered is the technical level and efficiency of the truck master. The old master takes less time to work in the same aisle width than the new master, and the manual hydraulic truck moves less frequently. If there are many newbies, or if the work time requirements are stricter, it is recommended to increase the safety gap.