Principles and steps for installing electric pallet truck parts by storage pallet truck manufacturers

In the operation of warehouse workshop, the application of electric pallet trucks has gradually become popular. When the bosses buy the electric pallet truck from the warehouse pallet truck manufacturer, due to the consideration of transportation space and safety issues, it is often not a finished product, and some parts need to be installed by themselves. Then, the installation of electric pallet trucks has become a very important issue. Next, follow us to understand the principles and steps of installing electric pallet truck components.

The installation of electric pallet trucks usually follows the installation principles from bottom to top, from inside to outside, from back to front, and from left to right. Let's take a look at the specific steps:

1. The piston ring should be used in a complete set, and cannot be disassembled and assembled arbitrarily. The installation starts from the third ring.

2. Do not touch the piston, crankshaft surface, connecting rod, piston, crankshaft, and camshaft at will. When installing these parts, apply oil evenly to protect and lubricate.

3. Grease the O-ring as required, and then install the cylinder liner. Storage pallet truck manufacturers remind everyone not to knock the cylinder liner during the installation process.

4. Remember not to install the ring vertically or horizontally. When installing the opening of the ring, it is appropriate to stagger it by at least 120°.

5. Another point for the storage pallet truck manufacturer to tell you is that the cylinder head gasket can be installed after the oil is applied, and the process is irreversible.

6. When installing the cylinder head screw, the warehouse pallet truck manufacturer should also remind everyone to pay attention that the wrench should be tightened from the middle to the four sides in 2-3 times to tighten the cylinder head screw to ensure that each screw The force is even, and then from the middle to both ends, tighten the crankshaft connecting rod in 2-3 times.

7. Install the piston connecting rod in the original direction of the piston as required, use special tools to install the piston connecting rod, also do not knock the piston, and evenly apply the oil on the connecting rod bush.

8. Pay attention to the alignment of the gears when installing the gears and camshafts of the high-pressure fuel injection pump. Storage pallet truck manufacturers consider this to be very important.

The above are the principles and steps for the storage pallet truck manufacturers to install electric pallet truck components, I hope our content can be helpful to everyone. If you have other questions about electric pallet trucks, please call us and we will provide you with warm service.